JeeHell FMGS forums

Hi JL,
Thanks for your update.

With B61.3.9 the Airbus’s tiller is working well on FSX. Only minor issue that the Parking brake status on ecam is shown on FSX as Differential brake instead of Parking brake. Then the GSX pushback is not possible.

I replaced the PERF folder., but the tiller still has no effect. For my case, in FSX taxi out for take off also has no NWS with tiller. I noticed the following lines in aircraft.ini, are different between 60.0.5 and 61.3.7 (with new PERF above) APrudtrimSpeed=0.075 APrudtrimSpeed_SE_max=0.8 APrudtri...

Thank you very much for continuing support FSX.
I installed the latest 61.3.7, only issue so far is the tiller has no effect, nose wheel steering is not working… axis of Tiller in FMGS Config is normal.

Exactly the same issue happens to me, but very randomly. Once the ovhd were not responding at the beginning of the flight (when taxi out for departure), once the ovhd were not responding at the end of the flight (when taxi in to the gate). Each time the ovhd not responding, the Engine start panel al...

I have the same issue, only when pulling the ALT Knob (OP DES)
Managed mode DES or V/S still smoothly pitch down.

Hi Michael,

Make sure the CPDLC AOC server is running.
It usually take a minute for start up then the ATSU menu in FMGS will start working.

jeehell wrote: ↑Thu Dec 14, 2023 1:10 pm ok that should be fixed with this simaptcher.dll to replace yours (only for FSX!)
https://www.jeehell.org/SimPatcher.dll

Dear Jean Luc,
This Simpatcher.dll works really well on FSX.
Thank you very much for your continuous FSX support !!

Hi Jean Luc, With fresh installation of B60.0.5, FSX is able to load the Simpatcher.DLL However right after the message "Tables found" shown up in simulator, the aircraft started to rotating unstoppable. Here is the Simpatcher.log "" 18:43:52 friction file:C:\A320FMGS\SimPatch\fr...

Hi Jean-Luc,

I attached the simpatch log file.
I tried changing value in simpatchConfig.ini to 120000 or 180000 but the module never start.

Hi Jean-Luc, I tried sleepTime=180000 for FSX B60.0.2 but the Simpatcher Module never start (no Simpatcher and airfile in Modules Menu), I waited for 60 minutes. Simconnect.dll is version 10.0.61637 [FSX Acceleration] Is there any other value that we can try for FSX ? [config] sleepTime=180000 Thanks

@Jean Luc, may be the version of simconnect is not matched the available version in the XwindOffset.ini file ? Xwind hack not preset, then simpatcher can not be loaded to the old simulator? Just my guess because I am having the similar issue with new Simpatcher and FSX Acceleration (currently using ...

Peter, vPilot allow only 1 com TX at all time. using the dot command to active which com to be Transmitt (TX) https://vpilot.rosscarlson.dev/Documentation#dot-commands You can map these command to you ACP buttons. Or by using Event ID to assign KEY_COM1_TRANSMIT_SELECT.......COM1_TRANSMIT_SELECT.......