JeeHell FMGS forums

Hi,

since the change from 59.0.0 to 60.0.6 I have a strange phenomenon that I was able to take a closer look at this weekend.


When I pass the threshold of the runway for landing, the nose is automatically pushed down quite drastically. The plane is shown in the video with the following config:

- Weights fit
- PERF Approach is set correctly
- Stable ILS Approach (LAND PHASE)
- AP1 = on
- ATHR = on

From 100ft (it looks to me as if this happens when passing the threshold) the nose pushes down. This is well before the actual flare procudure and, in my opinion, much too strong. This also happens when I fly manually, then I have to save the airplane from the strong impact with strong stick movements.

Tested with and without ActiveSky.

Can anyone reproduce this or has a tip?

It looks like this has to do with the trimwheel (I am using Skalarki).
I usually set "Disable Auto Trim = True" in Skalarki Profile as I don't like the noise of my 2015 TQ. If I set this to "False" (uncheck) the landings works like v59.0.0.

I found out that JH v60.0.6 has a new option "Pitch Trim Wheel Feedback" which is set to "no" on my setup. What does this stand for?

I can confirm if the Skalarki TQ is set to "Disable Auto Trim = True" you have to set FMGS Server to "Pitch Trim Wheel Feedback = yes"

this option is for some hardware trim wheels which are too slow to react, but in the case of skalarki it should not be used, I havent tested that in depth with all hardware obviously.